Previously install.sh ran `_vim_run 'PlugClean!'` unconditionally before
PlugInstall. PlugClean with bang removes any directory under
~/.vim/plugged not declared in the active profile's g:plugs, without
confirmation — silently nuking plugins a user has manually cloned to try
out, plus leftovers from older profile config (Goyo, Limelight, etc.).
Replace with a `list_extra_plugins` helper that runs a Vim subprocess
with all opt-in flags forced on and `$TMUX = '1'`, so the declared set
covers every plugin any chopsticks profile/flag combination could
register. Conditional plugins (vim-tmux-navigator, auto-pairs) are
therefore never flagged as extras.
When extras are detected:
- interactive: list them, ask before running PlugClean!
- --yes: leave in place, instruct the user to run :PlugClean manually
- otherwise (no extras): skip PlugClean entirely (saves an 80ms Vim
launch on the common case)
Closes#64
:ChopsticksStatus shows system tools, LSP servers, linters, and
formatters with OK/missing status. Helps new users discover what
to install without leaving Vim.
.vimrc:
- TTY detection: add empty($TERM) and dumb — fixes black screen when
TERM is unset (non-interactive SSH, minimal environments)
- Replace StartifyHeader() with a static ASCII list — removes the
synchronous system('git ...') call that caused the black screen while
vim waited for git before rendering, and removes Unicode block chars
(███╗) that rendered as garbage on terminals without full UTF-8
install.sh:
- _vim_run() helper: uses </dev/tty when accessible so vim properly
manages the alternate screen buffer and restores terminal state on
exit — this was the root cause of garbled output after PlugInstall
and CocInstall steps; falls back to --not-a-term for CI environments
- Remove 'screen may go dark' warning — no longer needed since terminal
state is properly managed via /dev/tty
Remove CHANGELOG.md — use git log
- README: one-liner curl install as primary method, updated Requirements
table to reflect auto-install capability, expanded Installation section
with 11-step installer description
- QUICKSTART: Step 1 now leads with curl one-liner, includes traditional
and --yes variants
- CHANGELOG: add v1.2.0 entry covering all robustness and get.sh changes
Documents the 15 best-practice settings absorbed from top global vim
configs (amix, tpope/vim-sensible, ThePrimeagen, YADR, spf13) that
were committed in the previous release but missing from the changelog.
