`,F` in normal mode mapped `gg=G\`\`` — reindent the entire file with
no confirmation. A muscle-typo of `,F` instead of `,f` (LSP format)
rewrites the whole buffer, and `=` does not always produce sensible
indentation for languages where Vim's internal indent expression is
poor.
Gate the normal-mode binding behind `g:chopsticks_enable_reindent_file`
(default off). The visual-mode binding (`vnoremap <leader>F =`) is
bounded by the user's selection and stays as default.
README's all-keybindings table now marks `,F re-indent (v)` to reflect
the visual-only default.
Closes#68
`set exrc` causes Vim to source `.vimrc`/`.exrc` from the current
working directory, which is a wider blast radius than the default
should accept for a config aimed at SSH/shared-host workflows.
`set secure` mitigates the most dangerous behaviors but still allows
arbitrary buffer state changes from an untrusted CWD.
Gate both behind `g:chopsticks_enable_exrc` (default off), following the
existing opt-in convention used for jk escape, Ctrl-S save, auto-pairs,
terminal keymaps, and completion keymaps.
Closes#62
:ChopsticksStatus shows system tools, LSP servers, linters, and
formatters with OK/missing status. Helps new users discover what
to install without leaving Vim.
.vimrc:
- TTY detection: add empty($TERM) and dumb — fixes black screen when
TERM is unset (non-interactive SSH, minimal environments)
- Replace StartifyHeader() with a static ASCII list — removes the
synchronous system('git ...') call that caused the black screen while
vim waited for git before rendering, and removes Unicode block chars
(███╗) that rendered as garbage on terminals without full UTF-8
install.sh:
- _vim_run() helper: uses </dev/tty when accessible so vim properly
manages the alternate screen buffer and restores terminal state on
exit — this was the root cause of garbled output after PlugInstall
and CocInstall steps; falls back to --not-a-term for CI environments
- Remove 'screen may go dark' warning — no longer needed since terminal
state is properly managed via /dev/tty
Remove CHANGELOG.md — use git log
- README: one-liner curl install as primary method, updated Requirements
table to reflect auto-install capability, expanded Installation section
with 11-step installer description
- QUICKSTART: Step 1 now leads with curl one-liner, includes traditional
and --yes variants
- CHANGELOG: add v1.2.0 entry covering all robustness and get.sh changes
Documents the 15 best-practice settings absorbed from top global vim
configs (amix, tpope/vim-sensible, ThePrimeagen, YADR, spf13) that
were committed in the previous release but missing from the changelog.
